A coordinated accent for your steering wheel
This three-piece set covers the trim around the left and right steering-wheel controls and the lower spoke. Molded ABS overlays attach with pre-applied double-sided adhesive without drilling.
Vehicle compatibility
- Jeep Wrangler JL/JLU: 2018–2026.
- Jeep Gladiator JT: 2020–2026.
Compare your original steering-wheel trim and control layout with the product photos before ordering. Not for Wrangler JK/JKU or aftermarket steering wheels.
Materials and finishes
ABS plastic with a decorative finish. Carbon Fiber and Red Carbon Fiber are carbon-fiber-look patterns on ABS, not genuine carbon fiber. All 12 finishes are priced per three-piece set.
Package contents
Three trim covers: left control surround, right control surround and lower-spoke cover. Steering wheel and vehicle are not included.
Installation instructions
- Park safely with the engine off. Test-fit all three covers with the adhesive backing still attached. Check the alignment and clearance around each control.
- Clean the original trim thoroughly, remove dust and oily residue, and let the surface dry completely.
- In cold conditions, gently warm the adhesive and trim with a hair dryer on a low setting. Avoid overheating.
- Peel off the adhesive backing. Align each cover carefully before pressing it onto the matching trim.
- Press firmly over the cover and along all edges for at least two minutes to help the adhesive bond evenly.
- Keep the area dry for 72 hours after installation and avoid pulling on the covers while the adhesive sets.
- Confirm that the steering-wheel buttons move freely and that the covers do not overlap the center airbag cover or its seams. Do not remove or modify the airbag assembly.
Reviews
There are no reviews yet.